LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1301 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement (With LMM) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Negative Battery Cable, Clip, Wiring Harness Ground & Bolt
    GM1873887Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) , Battery Negative Cable Disconnection and Connection (With Auxiliary Battery)  or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .
  2. Remove the negative battery cable clip (1) from the positive and negative cable bracket.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the engine wiring harness ground bolt (3).
  5. Reposition the engine wiring harness ground (4) and remove the negative battery cable (2) from the engine block.
    6. Fig 2: View Of Negative Battery Cable
    GM1873888Courtesy of GENERAL MOTORS CORP.
  6. Lower the vehicle.
  7. Remove the negative battery cable from the vehicle.
scientia non olet · About LEMON Manuals