Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the auxiliary battery positive cable to the vehicle.
- Install the auxiliary battery positive cable terminal to the relay stud.
- Install the auxiliary battery positive cable nut (6) to the rely stud and tighten to 7.5 N.m (66 lb in).
- Position the auxiliary battery positive cable boot (5) at the auxiliary battery relay.
- Install the auxiliary battery positive cable to the battery positive post.
- Tighten the auxiliary battery positive cable nut (2) and tighten to 7.5 N.m (66 lb in).
- Install the auxiliary battery positive cable terminal to the underhood junction block stud.
- Install the auxiliary battery positive cable nut (1) to the underhood junction block stud and tighten to 5 N.m (44 lb in).
- Install the auxiliary battery positive cable clips (4) to the engine wiring harness.
- Close the auxiliary battery positive cable post cover.
- Install the underhood junction block cover.
- Connect the auxiliary battery. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) , Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .
CAUTION:
Refer to Fastener Caution
.