LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1298 (Steering Wheel & Steering Column) >> Repair Instructions >> Upper Intermediate Steering Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Special Tool J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
    CAUTION: With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
    • The steering column
    • The intermediate shaft(s)
    • The steering gear

    After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.
  1. Install anti-rotation pin J 42640  in the steering column lower access hole.
  2. Mark the relationships of the following components:
    1. Mark the relationship of the upper intermediate steering shaft to the steering column.
    2. Mark the relationship of the upper intermediate steering shaft to the steering shaft coupling
    3. Fig 2: View Of Upper & Lower Intermediate Shafts & Components
    GM1701888Courtesy of GENERAL MOTORS CORP.
  3. Remove the steering shaft coupling nut (1) and bolt (2) at the upper intermediate steering shaft.
  4. Remove the steering column seal. Refer to Steering Column Seal Replacement .
    5. Fig 3: View Of Upper Intermediate Shaft Pinch Bolt, Nut & Steering Column
    GM1701530Courtesy of GENERAL MOTORS CORP.
  5. Remove the steering shaft coupling nut (1) and bolt (2) at the steering column.
  6. Remove the upper intermediate steering shaft from inside the engine compartment.
scientia non olet · About LEMON Manuals