Repair Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the steering wheel. Refer to Steering Wheel Replacement .
- Wash the wood section of the wheel with wax and grease remover.
- Mask off the non-wood area of the steering wheel.
- Sand with 400 grit sand paper first. Finish sanding with 600 grit.
- Wash the wood section of the wheel again with wax and grease remover.
- Clear coat the steering wheel using the appropriate information in the body repair section.
- Install the steering wheel. Refer to Steering Wheel Replacement .
IMPORTANT:
Do NOT sand through the clear.