LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1297 (Instrument Panel System Displays & Gauges) >> Diagnostic Information and Procedures >> Water in Fuel Indicator Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the water in fuel sensor.
  2. Connect a DMM between terminal A and terminal B of the sensor harness connector.
  3. Measure the resistance of the sensor while moving the float up and down the float barrel.
  4. The resistance should switch from less than 0.5 ohm and 0.L.
    • If the resistance did not change, replace the water in fuel sensor.
scientia non olet · About LEMON Manuals