Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the lever (7) to the upper mode door/upper HVAC module case (6).
- Install the HVAC module assembly halves.
- Install the screws to the HVAC module assembly.
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
- Install the mode actuator to the HVAC module assembly.
- Install the screws to the mode actuator.
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
- Connect the electrical connector to the mode actuator.
- Install the HVAC module. Refer to Air Conditioning and Heater Module Assembly Replacement .
CAUTION:
Refer to Fastener Caution
.
NOTE:
For every heat stake removed ensure that you install a screw.