DTC Set By The Radio (-Y91) (-U42)
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the X3 harness connector at the amplifier.
- Radio ON, test for 5.0-7.5 volts between the appropriate signal circuit terminal listed below and ground.
- - - - Left front low level audio signal (+) - terminal 15
- Left front low level audio signal (-) - terminal 7
- Right front low level audio signal (+) - terminal 14
- Right front low level audio signal (-) - terminal 6
- Left rear low level audio signal (+) - terminal 13
- Left rear low level audio signal (-) - terminal 5
- Right rear low level audio signal (+) - terminal 12
- Right rear low level audio signal (-) - terminal 4
- If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
- If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
- If all circuits test normal, replace the amplifier.