LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1294 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side (JF3, JF7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Park Brake Cable & Intermediate Cable Equalizer Bar
    GM1850956Courtesy of GENERAL MOTORS CORP.
  1. Release the park brake.
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the right park brake cable (1) from the intermediate cable equalizer bar (2).
  5. Release the right park brake cable from the frame bracket by compressing the locking tabs and pulling the cable conduit (3) rearward.
    6. Fig 2: Locating Park Brake Cable Mounting
    GM1850957Courtesy of GENERAL MOTORS CORP.
  6. Release the park brake cable (1) from the rear axle housing cover clip.
  7. Remove the park brake cable clip bolt (2).
  8. Remove the park brake cable from the cable guides.
  9. Remove the brake shoes. Refer to Brake Shoe Replacement .
    10. Fig 3: Using J 37043 To Release Brake Cable From Backing Plate
    GM1276848Courtesy of GENERAL MOTORS CORP.
  10. Using the J 37043  (1), remove the park brake cable from the backing plate. See Special Tools .
    11. Fig 4: Identifying Park Brake Cable
    GM1471719Courtesy of GENERAL MOTORS CORP.
  11. Remove the park brake cable from the vehicle.
scientia non olet · About LEMON Manuals