LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1294 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side (JF3, JF7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Park Brake Cable
    GM1471719Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake cable to the vehicle.
  2. Install the brake shoes. Refer to Brake Shoe Replacement .

    Ensure the locking tabs on the cable conduit are fully engaged into the rear axle bracket.

    3. Fig 2: Locating Park Brake Cable Mounting
    GM1850957Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the park brake cable clip bolt (2).

    Tighten:  Tighten the bolt to 22 N.m (16 lb ft).

  4. Connect the park brake cable (1) to the rear axle housing cover clip.
  5. Install the park brake cable to the cable guides.
    6. Fig 3: Identifying Park Brake Cable And Intermediate Cable Equalizer Bar
    GM1850956Courtesy of GENERAL MOTORS CORP.
  6. Connect the right rear park brake cable (1) to the intermediate cable equalizer bar (2).
  7. Insert the park brake cable conduit (3) into the frame bracket.

    Ensure the locking tabs on the cable conduit are fully engaged into the frame bracket.

  8. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
  9. Adjust the park brake. Refer to Parking Brake Adjustment (Drum Brake)  or Parking Brake Adjustment (Disc Brake) .
scientia non olet · About LEMON Manuals