Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Brake Cable Conduit & Park Brake Cable Eye

Courtesy of GENERAL MOTORS CORP.

Connect the left park brake cable eye (2) to the park brake actuator lever.
Install the park brake cable to the rear axle bracket by pulling the cable conduit (1) rearward and inserting the cable conduit into the rear axle bracket.
Ensure the locking tabs on the cable conduit are fully engaged into the rear axle bracket.

Fig 2: Identifying Park Brake Cable Clip Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the park brake cable clip bolt.
Tighten: Tighten the bolt to 22 N.m (16 lb ft).

Fig 3: Identifying Park Brake Cable And Intermediate Cable Equalizer

Courtesy of GENERAL MOTORS CORP.

Connect the left rear park brake cable (1) to the intermediate cable equalizer bar (2).
Insert the park brake cable conduit (3) into the frame bracket.
Ensure the locking tabs on the cable conduit are fully engaged into the frame bracket.
Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
Adjust the park brake. Refer to Parking Brake Adjustment (Drum Brake) or Parking Brake Adjustment (Disc Brake) .