LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1294 (Parking Brake System) >> Repair Instructions >> Parking Brake Intermediate Cable Replacement (JD9, JF3, JF7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Cable And Park Brake Cable Connector
    GM1850950Courtesy of GENERAL MOTORS CORP.
  1. Release the park brake.
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the front park brake cable (2) from the intermediate cable connector by drilling a 3 mm (1/8 in) hole through the dimple in the front to intermediate park brake cable connector (1).
    5. Fig 2: Park Brake Cable, Equalizer Bar And Intermediate Park Brake Cable
    GM1850952Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the left park brake cable (1) and the right park brake cable (2) from the equalizer bar (3) on the intermediate park brake cable.
  6. Remove the intermediate park brake cable.
scientia non olet · About LEMON Manuals