Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Park Brake Warning Lamp Switch Mounting Bolt

Courtesy of GENERAL MOTORS CORP.

Install the park brake warning lamp switch.

CAUTION: Refer to Fastener Caution .

Install the park brake warning lamp switch bolt and tighten to 3 N.m (27 lb in).

Fig 2: Identifying Park Brake Warning Lamp Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the park brake warning lamp switch electrical connector.
Install the left side instrument panel electrical center/junction block. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Left Side .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) , Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .