LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1293 (Lighting Systems) >> Repair Instructions >> Stop Lamp Switch Replacement (With Adjustable Pedals) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the park brake.
  2. Remove the driver knee bolster. Refer to Knee Bolster Replacement (With RPO SLT) or Knee Bolster Replacement (Without RPO SLT) .
  3. Disconnect the stoplamp switch electrical connector.
    4. Fig 1: Locating Brake Booster Pushrod Retainer Bolt
    GM1892143Courtesy of GENERAL MOTORS CORP.
  4. Remove the power vacuum brake booster pushrod retainer bolt (1).
    5. Fig 2: Locating Brake Booster Pushrod Retainer
    GM1892145Courtesy of GENERAL MOTORS CORP.
  5. Remove the power vacuum brake booster pushrod retainer (1).
    6. Fig 3: View Of Stoplamp Switch
    GM1892146Courtesy of GENERAL MOTORS CORP.
  6. Slide the power vacuum brake booster pushrod off of the brake pedal pin and remove the stoplamp switch (1).
scientia non olet · About LEMON Manuals