LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1293 (Lighting Systems) >> Repair Instructions >> Stop Lamp Switch Replacement (With Adjustable Pedals) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stoplamp Switch
    GM1892146Courtesy of GENERAL MOTORS CORP.
  1. Install the stoplamp switch (1) to the power vacuum brake booster pushrod.
  2. Install the power vacuum brake booster pushrod with the stoplamp switch to the brake pedal pin.
    3. Fig 2: Locating Brake Booster Pushrod Retainer
    GM1892145Courtesy of GENERAL MOTORS CORP.
  3. Install the power vacuum brake booster pushrod retainer (1).
  4. Rotate the pushrod retainer 360 degrees to verify the retainer is fully engaged in the groove on the brake pedal pin.
    5. Fig 3: Locating Brake Booster Pushrod Retainer Bolt
    GM1892143Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Install the power vacuum brake booster pushrod retainer bolt (1) and tighten to 10 N.m (89 lb in).
  6. Connect the stoplamp switch electrical connector.
  7. Install the driver knee bolster. Refer to Knee Bolster Replacement (With RPO SLT) or Knee Bolster Replacement (Without RPO SLT) .
scientia non olet · About LEMON Manuals