Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of License Lamp (W/ Step Bumper)

Courtesy of GENERAL MOTORS CORP.

Install the bulb.
Install the rear edge of the lens housing into the rear bumper.
Push on the lens side of the housing in order to snap the housing into the rear bumper assembly.
Inspect the operation.