Circuit/System Verification
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, verify that the DTC is set as current and that no other vehicle system DTCs exists.
- If other vehicle system DTCs exists, address these DTCs before proceeding with this diagnostic test.
- Cycle the ignition OFF then ON, clear the DTC with a scan tool and verify that the DTC does not reset as current.
- If the DTC resets as current, replace the BCM.