Sunroof Panel/Window Garnish Molding Replacement (Crew Cab)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Sunroof Panel/Window Garnish Molding Assembly Tip: Tilt molding approximately 45 degrees with rear end up. Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs. Grab front of molding at centerline and pull rearward approximately 1 inch. Push front edge up, locking front tabs in place. Push up on outboard edges of molding to secure. After molding is secured, slide the molding forward until it stops.

Callout

Component Name

Sunroof Panel/Window Garnish Molding Assembly
Tip:

Tilt molding approximately 45 degrees with rear end up.
Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs.
Grab front of molding at centerline and pull rearward approximately 1 inch.
Push front edge up, locking front tabs in place.
Push up on outboard edges of molding to secure.
After molding is secured, slide the molding forward until it stops.