Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Position the sunroof motor/actuator (3) to the sunroof module.
- Push the sunroof motor/actuator straight upward to engage the drive gear between the cables housed within the sunroof cable drive tubes.
- Install the sunroof motor/actuator screws (2) to the sunroof actuator.
Tighten: Tighten the screws to 4 N.m (35 lb in).
- Connect the electrical connector (1) to the sunroof motor/actuator.
- Install the headliner. Refer to Headlining Trim Panel Replacement (Crew Cab) , Headlining Trim Panel Replacement (Extended Cab) or Headlining Trim Panel Replacement (Regular Cab) .
- Initialize/teach the sunroof motor/actuator. Refer to Sunroof Motor/Actuator Initialization/Teach Process (Crew Cab Existing Motor) , Sunroof Motor/Actuator Initialization/Teach Process (Extended Cab New Motor) , Sunroof Motor/Actuator Initialization/Teach Process (Extended Cab Existing Motor) or Sunroof Motor/Actuator Initialization/Teach Process (Crew Cab New Motor) .
- Inspect the sunroof for proper operation.
- Refer to Control Module References for programming and setup information.
CAUTION:
Refer to Fastener Caution
.