Rear Side Door Trim Panel Replacement (YE9)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Trim Panel (YE9)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the window control switch, if equipped. Refer to Rear Side Door Window Switch Replacement (Crew Cab) or Rear Side Door Window Switch Replacement (Extended Cab) . Remove the door window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement .
1	Rear Side Door Locking Rod Knob Assembly Procedure Lower window. Ensure locking rod is in the unlocked position. Use a flat-bladed tool to disengage detent tab and then remove knob by pulling upward. When re-installing, push knob down until detent tab touches locking rod opening cover. Push detent tab in to lock knob to locking rod.
2	Rear Side Door Release Handle Cover
3	Rear Side Door Armrest Opening Cover
4	Rear Side Door Trim Panel Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 9 N.m (18 lb in)
5	Rear Side Door Trim Panel Assembly Procedure Depress both tabs to remove cable and pull cable rearward out of handle assembly. When reinstalling cable make sure that it is fully seated past the guide tab. There are two hooks located on the lower portion of the door trim panel that are being used for manufacturing installation ONLY. If these hook are damaged during either removal or installation of the door trim panel, replacement of the panel is not required.
6	Rear Side Door Trim Panel Retainer (Qty: 10)