Rear Side Door Trim Panel Replacement (SLT)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Trim Panel Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove rear door window control switch. Refer to Rear Side Door Window Switch Replacement (Crew Cab) or Rear Side Door Window Switch Replacement (Extended Cab) .
1	Rear Side Door Locking Rod Knob Assembly Procedure Lower the window. Ensure the locking rod is in the unlocked position. Use a flat-bladed tool to disengage detent tab, then remove knob by pulling upward. When re-installing, push the knob down, until the detent tab touches locking rod opening cover. Push the detent tab in to lock knob to locking rod.
2	Rear Side Door Trim Panel Cover
3	Rear Side Door Trim Panel Cover Retainer (Qty: 4)
4	Rear Side Door Inside Handle Bezel Cover
5	Rear Side Door Trim Panel Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 9 N.m (18 lb in)
6	Rear Side Door Trim Panel Assembly
7	Rear Side Door Cable Retainer Tip: Depress both tabs to remove cable and pull cable rearward out of handle assembly. When reinstalling cable make sure that it is fully seated past the guide tab.
8	Rear Side Door Trim Panel Retainer (Qty: 10)