LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1289 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1001 (PPS) >> Circuit/System Verification (PPS)

Circuit/System Verification (PPS)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected.
  • PPS
  • PPS wiring harness
  1. Verify the correct PPS part number has been installed
    • If the wrong PPS part number was installed, replace with the correct PPS.
  2. Verify that DTC B1001 is not set as current in the PPS.
    • If DTC is set as current, perform the Setup New PPS procedure. Verify the SDM is sending the correct key. If DTC resets replace the PPS.
scientia non olet · About LEMON Manuals