Instrument Panel Carrier Support Replacement (With RPO SLT)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Instrument Panel Carrier Support Assembly & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the instrument panel carrier assembly. Refer to Instrument Panel Carrier Replacement . Remove the body control module bracket. Refer to Body Control Module Bracket Replacement . Remove the communication interface module, if equipped. Refer to Communication Interface Module Replacement (with RPO SLT) or Communication Interface Module Replacement (without RPO SLT) . Remove the digital radio receiver, if equipped. Refer to Digital Radio Receiver Replacement .
1	Instrument Panel Carrier to HVAC Duct Screws (Qty 2) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
2	Instrument Panel Carrier Support Assembly Bolt (Qty: 1) Tighten: 9 N.m (80 lb in)
3	Instrument Panel Carrier Support Assembly Bolts (Qty: 4) Tighten: 22 N.m (16 lb ft)
4	Instrument Panel Carrier Support Assembly Procedure Note location and routing of the instrument panel wiring harness prior to removal of the instrument panel carrier support assembly to ensure proper reinstallation. Disconnect the wiring harness from the instrument panel carrier support assembly. With the aid of an assistant, remove the instrument panel carrier support assembly from the vehicle. If replacing the instrument panel carrier support assembly, transfer all necessary components.