Driver or Passenger Seat Back Cushion Cover and Pad Replacement

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Seat Back Cover, Cushion Pad & Seat Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Remove the front seat back panel. Refer to Driver or Passenger Seat Back Cushion Finish Panel Replacement . Remove the front seat manual lumbar knob, if equipped. Refer to Lumbar Support Knob Replacement . Remove the front seat adjuster outer finish cover. Refer to Front Seat Cushion Outer Trim Panel Replacement (Power) or Front Seat Cushion Outer Trim Panel Replacement (Manual) .
1	Front Seat Adjuster Inner Finish Cover Refer to Front Seat Cushion Inner Trim Panel Replacement .
2	Front Seat Back Cushion Finish Panel Refer to Driver or Passenger Seat Back Cushion Finish Panel Replacement .
3	Front Seat Head Restraint Assembly Refer to Head Restraint Replacement .
4	Front Seat Head Restraint Guide (Qty: 2) Refer to Head Restraint Guide Replacement .
5	Seat Back Cushion Cover Procedure Disengage the j-channel retainers from the seat back cushion frame. Remove the rear seat recliner to seat cushion frame bolt on each side and tilt the seat back forward to make it easier to remove and install the cover. Disconnect the blower from the seat back cushion pad, if equipped. Remove the air duct, if equipped. Disconnect the electrical connectors that attach to the seat back cushion, if equipped. Remove the seat back cushion cover and pad from the seat cushion frame as an assembly. Pull the cover away from the pad to disengage the retainers
6	Seat Back Cushion Pad