LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1285 (Bumper System And Fascia) >> Repair Instructions >> Front Bumper Fascia Trim Cap Replacement (GMC)

Front Bumper Fascia Trim Cap Replacement (GMC)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Bumper Fascia Trim Cap (GMC)
GM1830284Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the front wheelhouse liner - right side. Refer to Front Wheelhouse Liner Replacement - Right Side (Chevrolet) or Front Wheelhouse Liner Replacement - Right Side (GMC) .
  2. Remove the front wheelhouse liner - left side. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
1 Front Bumper Fascia Trim Cap Bolt (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tighten:  10 N.m (89 lb in)
2 Front Bumper Fascia Trim Cap

Procedure

  1. Pull gently on the sides of the front bumper fascia trim cap outwards to disengage from the front fenders.
  2. Transfer parts as needed.
  3. Disconnect any electrical connectors.
scientia non olet · About LEMON Manuals