Pickup Box Endgate Latch Handle Bezel Replacement (Pickup)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Pickup Box Endgate Latch Handle Bezel (Pick Up)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Pickup Box Endgate Latch Handle Bezel Bolt Procedure: Remove the bolt prior to releasing the latch handle bezel from the endgate outer panel. CAUTION: Refer to Fastener Caution . Tighten: 25 N.m (18 lb ft)
2	Pickup Box Endgate Latch Handle Bezel Procedure Release the 3 retainer clips securing the bezel to the endgate outer panel. Lift the endgate latch handle in order to aid in the removal of the latch handle bezel. Disconnect the rearview camera, if equipped. Refer to Rearview Camera Replacement .

Callout

Component Name

Pickup Box Endgate Latch Handle Bezel Bolt
Procedure:
Remove the bolt prior to releasing the latch handle bezel from the endgate outer panel.

CAUTION: Refer to Fastener Caution .

Tighten: 25 N.m (18 lb ft)

Pickup Box Endgate Latch Handle Bezel

Procedure

Release the 3 retainer clips securing the bezel to the endgate outer panel.
Lift the endgate latch handle in order to aid in the removal of the latch handle bezel.
Disconnect the rearview camera, if equipped. Refer to Rearview Camera Replacement .