Decal or Stripe Replacement (HYBRID 2 Mode Rear Glass Decal)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Rear Glass Decal

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Heat the decal using a J-25070: gun or equivalent, 152 mm (6 in) from the glass surface. Apply the heat using a circular motion, for about 30 seconds. CAUTION: Refer to Exterior Trim Emblem Removal Caution . Remove the decal from the surface using a plastic, flat-bladed tool. Remove all adhesive from the surface using a 3M™ Scotch Brite molding adhesive remover disk, 3M™ P/N 07501, or equivalent. Clean the surface using 3M™ General Purpose Adhesive Cleaner, P/N 08984 or equivalent. Special Tools: J-25070: Heat Gun 500-750°F
1	HYBRID Rear Glass Decal Tip: The rear glass decal is serviced as one part.

Callout

Component Name

Preliminary Procedures

Heat the decal using a J-25070: gun or equivalent, 152 mm (6 in) from the glass surface.
Apply the heat using a circular motion, for about 30 seconds.

CAUTION: Refer to Exterior Trim Emblem Removal Caution .

Remove the decal from the surface using a plastic, flat-bladed tool.
Remove all adhesive from the surface using a 3M™ Scotch Brite molding adhesive remover disk, 3M™ P/N 07501, or equivalent.
Clean the surface using 3M™ General Purpose Adhesive Cleaner, P/N 08984 or equivalent.

Special Tools: J-25070: Heat Gun 500-750°F

HYBRID Rear Glass Decal
Tip: The rear glass decal is serviced as one part.