LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1268 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Crankshaft Balancer Removal >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Special Tool J 42386-A & Bolts
    GM1658136Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.
  1. Install the J 42386-A  (1) and bolts. See Special Tools .

    Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation.

    Tighten:  Tighten the J 42386-A  bolts to 50 N. See Special Tools .m (37 lb ft).

    2. Fig 2: View Of Crankshaft Balancer Bolt
    GM1658287Courtesy of GENERAL MOTORS CORP.
  2. Remove the crankshaft balancer bolt (139).

    Do not discard the crankshaft balancer bolt. The balancer bolt is used during the balancer installation procedure.

    3. Fig 3: View Of Crankshaft Balancer With J 41816 & J 41816-2 Removal Tools
    GM1402060Courtesy of GENERAL MOTORS CORP.
  3. Use the J 41816-A  (1) and the J 41816-2  (2) in order to remove the crankshaft balancer. See Special Tools .
    4. Fig 4: View Of Crankshaft Balancer
    GM1658138Courtesy of GENERAL MOTORS CORP.
  4. Remove the balancer (138).
    5. Fig 5: View Of Special Tool J 42386-A & Bolts
    GM1658136Courtesy of GENERAL MOTORS CORP.
  5. Remove the J 42386-A  (1) and bolts. See Special Tools .
scientia non olet · About LEMON Manuals