Park Pawl and Actuator Replacement

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Park Pawl and Actuator Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the manual shift shaft position switch. Refer to Manual Shift Shaft Position Switch Replacement . Remove the park pawl cover. Refer to Park Pawl Cover and Gasket Replacement . Remove the rear case. Refer to Rear Case and Gasket Replacement (2WD) or Rear Case and Gasket Replacement (4WD) .
1	Park Pawl Shaft Hole Plug
2	Park Pawl Shaft
3	Park Pawl Actuator Guide Pin
4	Park Pawl
5	Park Pawl Spring
6	Park Pawl Actuator Guide Tip: Push the park pawl into housing in order to remove the park pawl actuator guide.
7	Park Pawl Actuator