LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Automatic Transmission Servicing (4L80-E)) >> Removal & Installation >> Shift Cable >> Removal

Shift Cable: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the parking brake. Position the steering column shift lever to Park. Remove the knee bolster trim panel. Remove the knee bolster bracket.
  2. Remove the clip securing the shift cable to the steering column bracket. Remove the shift cable from the steering column shift control. Remove the rubber grommet from the floor panel. Remove the air cleaner assembly.
  3. Remove the shift cable clips from the left front of the engine compartment. Raise the vehicle. Remove the shift cable clips from the left rear engine bracket. See Figure .
  4. Remove the shift cable from the stud ball. Remove the locking clip from the cable at the bracket. Lower the vehicle. Remove the shift cable from the vehicle.