Tools Required

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

EN 46104 Water Pump Pulley Holding Tool

Fig 1: View Of Water Pump & Bolts

Courtesy of GENERAL MOTORS CORP.

Ensure that the engine front cover and water pump are clear of old gasket material.
Place a new water pump gasket on the water pump.
Place the water pump in position on the front cover.

NOTE: Refer to Fastener Notice .

Install the water pump bolts.
Tighten: Tighten the water pump bolts to 10 N.m (89 lb in).

Fig 2: View Of Water Pump Pulley & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the water pump pulley.
Loosely install the water pump pulley bolts.

Fig 3: View Of EN 46104 Tool & Water Pump Pulley

Courtesy of GENERAL MOTORS CORP.

Install the EN 46104 (1) onto the water pump pulley.
Tighten: Tighten the water pump pulley bolts to 10 N.m (89 lb in).