LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1162 (Engine Mechanical - 3.6L (6 Of 6)) >> Off-Vehicle R EPAIR Instructions (4 Of 4) >> Engine Coolant Thermostat Housing Installation

Engine Coolant Thermostat Housing Installation

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Thermostat and Housing O-Ring
    GM1888110Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW thermostat housing O-ring.
    2. Fig 2: Identifying Thermostat Housing Assembly
    GM1888107Courtesy of GENERAL MOTORS CORP.
  2. Install the thermostat housing.
    3. NOTE: Refer to Fastener Notice .
  3. Install the thermostat housing bolts.

    Tighten:  Tighten the thermostat housing bolt to 10 N.m (89 lb in).

    4. Fig 3: Identifying Thermostat Housing Assembly
    GM1888103Courtesy of GENERAL MOTORS CORP.
  4. Install the NEW thermostat housing assembly O-ring and gasket.
    5. Fig 4: View of Thermostat Housing Assembly
    GM1888100Courtesy of GENERAL MOTORS CORP.
  5. Install the thermostat housing assembly.
  6. Install the thermostat housing assembly bolts.

    Tighten:  Tighten the thermostat housing assembly bolt to 10 N.m (89 lb in).

    7. Fig 5: View Of Heater Inlet/Outlet Pipe Assembly O-Ring & Gasket
    GM1665644Courtesy of GENERAL MOTORS CORP.
  7. Install the NEW heater inlet/outlet pipe assembly O-ring and gasket.
    8. Fig 6: View Of Heater Inlet/Outlet Pipe Assembly
    GM946082Courtesy of GENERAL MOTORS CORP.
  8. Install the heater inlet/outlet pipe assembly.
  9. Install the heater inlet/outlet pipe assembly bolts.

    Tighten:  Tighten the heater inlet/outlet pipe assembly bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals