LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1153 (Front Drive Axle) >> Repair Instructions >> Front Drive Axle Intermediate Shaft Bearing Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intermediate Shaft Bearing Housing, Shaft Bearing & Snap Ring
    GM908027Courtesy of GENERAL MOTORS CORP.
  1. Install the intermediate shaft bearing (2) to the intermediate shaft bearing housing (3).
  2. Using the J 21474-20  and a hydraulic press, install intermediate shaft bearing (2) to the intermediate shaft bearing housing (3).
  3. Install the snap ring (1) in the intermediate shaft bearing housing (3).
    4. Fig 2: View Of Intermediate Shaft Bearing Assembly
    GM908025Courtesy of GENERAL MOTORS CORP.
  4. Install the intermediate shaft bearing assembly to the intermediate wheel drive shaft.
    5. NOTE: Refer to Fastener Notice .
  5. Install the intermediate shaft bearing housing mounting bolts to the oil pan.

    Tighten:  Tighten the intermediate shaft bearing assembly mounting bolts to 60 N.m (44 lb ft).

    6. Fig 3: View of Retaining Ring Assembly
    GM1957674Courtesy of GENERAL MOTORS CORP.
  6. Apply a small amount of grease GM P/N 01051344, (Canadian P/N 993037) to the intermediate wheel drive shaft splines.
  7. Install a new O-ring (1) and the new wheel drive shaft retaining ring (2).
  8. Install the left front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Left Side .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals