Repair Verification
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, seal the EVAP system with a scan tool.
- Turn the nitrogen/smoke valve on the J 41413-200 to nitrogen. See Special Tools .
- Use the remote switch to activate the J 41413-200 and pressurize the fuel tank with nitrogen to 5 inches H20. See Special Tools .
- Observe the scan tool FTP sensor parameter, command the EVAP vent valve OFF.
- Verify the FTP Sensor parameter is 0 inches H2O.
IMPORTANT:
DO NOT exceed the specified value in this step. Exceeding the specified value may produce incorrect test results.