Circuit/System Testing: Notes
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
B2345 13
- Ignition OFF, disconnect the X2, X5 harness connector at the memory seat module.
- Test for greater than 1.9K ohms between the following temperature sensor signal and low reference circuits.
- Driver seat cushion terminal 1 X5 and terminal 3 X2
- Passenger seat cushion terminal 2 X5 and terminal 6 X2.
- If less than the specified value, test for a short between the signal and low reference circuits. If the circuits test normal, replace the appropriate temperature sensor.
- If all circuits test normal, replace the memory seat module.