Sunload Sensor Circuit Malfunction
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the sunload sensor.
- Ignition OFF, test for less than 10 ohms of resistance between the low reference circuit terminal C and ground.
- If greater than the specified range, test the ground circuit for high resistance.
- Ignition ON, test for 4.8-5.2 volts between the low reference circuit terminal C and the appropriate signal circuit terminal.
- Left sunload sensor circuit terminal A.
- Right sunload sensor circuit terminal B.
- If less than the specified range, test the signal circuit for high resistance. If the circuit tests normal, replace the HVAC control module.
- If all circuits test normal, test or replace the sunload sensor.