Removal Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027 - LY7) or Fuel Pressure Relief (Without CH 48027 - LY7) or Fuel Pressure Relief (With High Pressure Pump - LLT) .
- Remove the retainer from the quick-connect fitting.
- Blow dirt out of the fitting using compressed air.
- Depending on the fuel line size and ability to access the fitting, choose the appropriate tool: J 37088-A or J 44581 . See Special Tools . Insert the J 37088-A or J 44581 into the female connector, then push inward to release the locking tabs. See Special Tools .
- Pull the connection apart.
- Using a clean shop towel, wipe off the male pipe end.
- Inspect both ends of the fitting for dirt and burrs.
- Clean or replace the components as required.
CAUTION:
Refer to Gasoline/Gasoline Vapors Caution
.
CAUTION:
Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.
NOTE:
If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.