LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Knock Sensor
    GM860802Courtesy of GENERAL MOTORS CORP.
  1. Install the KS.
    2. NOTE: Refer to Fastener Notice .
  2. Install the KS bolt.

    Tighten:  Tighten the KS bolt to 23 N.m (17 lb ft).

    3. Fig 2: View Of Left Knock Sensor And Electrical Connector
    GM945380Courtesy of GENERAL MOTORS CORP.
  3. Install the KS electrical connector.
  4. Install the wiring harness heat shield to the oil level indicator tube.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals