LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Knock Sensor And Electrical Connector
    GM945742Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Reposition the wiring harness heat shield to obtain access.
  4. Remove the knock sensor (KS) electrical connector.
    5. Fig 2: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
  5. Remove the KS bolt.
  6. Remove the KS.
scientia non olet · About LEMON Manuals