LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Pressure Sensor Electrical Connector
    GM1558059Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the fuel tank pressure sensor electrical connector (1).
    3. Fig 2: Removing/Installing Fuel Tank Pressure Sensor
    GM1558061Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.
  3. Remove the fuel tank pressure sensor from the evaporative emission (EVAP) canister.
scientia non olet · About LEMON Manuals