LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of EVAP Canister Vent Valve
GM827315Courtesy of GENERAL MOTORS COMPANY
  1. Insert the EVAP canister vent valve into the EVAP canister
  2. Twist the EVAP canister vent valve clockwise into the locked position
  3. Connect the electrical connector to the EVAP canister vent valve
  4. Attach the EVAP canister to the body by inserting the fresh air tube and tab on the canister forward into the body brace.
  5. Rotate the rear of the canister up over the 2 weld studs on the floor pan
  6. Install the EVAP canister to the body and install the bolts and tighten to 6 N.m (53 lb in).
    7. Fig 2: View of Front Differential Mounting Bolts
    GM1970358Courtesy of GENERAL MOTORS COMPANY
  7. Sedan/Wagon only: Raise the rear differential into position and install the front mounting bolts (1)and tighten to 175 N.m (129 lb ft).
  8. Install the exhaust system. Refer to EXHAUST SYSTEM REPLACEMENT (WITH LY7 AND LLT) or EXHAUST SYSTEM REPLACEMENT (WITH LP1)
scientia non olet · About LEMON Manuals