LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear frame. Refer to Rear Frame Replacement .
    2. Fig 1: Identifying EVAP Hoses At EVAP Canister
    GM785817Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the evaporative emission (EVAP) hoses from the EVAP canister.
  3. Disconnect the electrical connector from the EVAP canister.
    4. Fig 2: View Of EVAP Canister Retaining Nuts
    GM785820Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP canister retaining nuts.
  5. Complete the following in order to remove the EVAP canister:
    1. Lower the rear of the canister enough to clear the 2 weld studs.
    2. Slide the canister rearward from the body brace.
scientia non olet · About LEMON Manuals