LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Crankshaft Position (CKP) Sensor
    GM1311144Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft position sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the crankshaft position sensor bolt.

    Tighten:  Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).

    3. Fig 2: Locating CKP Electrical Connector
    GM887868Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP electrical connector (3).
  4. Install the wiring harness heat shield to the oil level indicator tube.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals