LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right CMP Sensor - Intake
    GM1285251Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Right CMP Sensor Electrical Connector - Intake
    GM1285245Courtesy of GENERAL MOTORS CORP.
  3. Connect the CMP sensor electrical connector.
  4. Install the front compartment sight shields as necessary. Refer to Front Compartment Sight Shields Replacement .
scientia non olet · About LEMON Manuals