LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.
    2. Fig 1: View Of Right CMP Actuator Valve - Exhaust
    GM1285202Courtesy of GENERAL MOTORS CORP.
  2. Install the CMP actuator valve.
    3. NOTE: Refer to Fastener Notice .
  3. Install the CMP actuator valve bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of Right CMP Actuator Valve Electrical Connector - Exhaust
    GM1285201Courtesy of GENERAL MOTORS CORP.
  4. Connect the CMP valve electrical connector.
  5. Install the front compartment sight shields as necessary. Refer to Front Compartment Sight Shields Replacement .
scientia non olet · About LEMON Manuals