LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Automatic Transmission Servicing (4L60-E)) >> Removal & Installation >> 2-4 Servo >> Installation

2-4 Servo: Installation

WARNING: This page is about a different car, the 2003 GMC Savana and 2003 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new seals on the pistons and the servo cover. Lubricate the seals with clean transmission fluid. Install the 2-4 servo assembly into the 2-4 servo bore. Install the servo cover and "O" ring seal.
  2. Install the servo cover depressor. See Figure . Tighten the bolt on the servo cover depressor in order to compress the servo cover. Install the servo cover retaining ring. Remove the servo cover depressor from the oil pan flange.
  3. Install the oil pan bolt. Tighten the oil pan bolt to specification. See TORQUE SPECIFICATIONS  . Install the 2 heat shield retaining bolts and the heat shield from the transmission. Tighten the bolts to specification. See TORQUE SPECIFICATIONS  . Lower the vehicle. Fill transmission with appropriate fluid to proper level. See RECOMMENDED FLUIDS  and FLUID CAPACITIES  under LUBRICATION.
scientia non olet · About LEMON Manuals