LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1122 (Hydraulic Brake System) >> Repair Instructions >> Rear Brake Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Hose Fitting, Gaskets and Bolt
    GM1969966Courtesy of GENERAL MOTORS CORP.
  1. Assemble the brake hose fitting bolt (1) with 2 new brake hose fitting gaskets (2) to the brake hose (3).
    2. NOTE: Refer to Fastener Notice .
  2. Install the brake hose assembly to the caliper.

    Tighten:  Tighten the brake hose fitting bolt to 49 N.m (36 lb ft).

    3. Fig 2: View of Rear Brake Hose Retainer Clip
    GM1969965Courtesy of GENERAL MOTORS CORP.
  3. Install the rear brake hose retainer clip (1).
    4. Fig 3: View Of Rear Brake Pipe Fitting
    GM1969964Courtesy of GENERAL MOTORS CORP.
  4. Connect the rear brake pipe fitting (1).

    Tighten:  Tighten the fitting to 18 N.m (13 lb ft).

  5. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals