LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1122 (Hydraulic Brake System) >> Repair Instructions >> Front Brake Hose Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Brake Hose and Bolt
    GM1969922Courtesy of GENERAL MOTORS CORP.
  1. Assemble the brake hose fitting bolt (1) with 2 new brake hose fitting gaskets (2) to the brake hose (3).
    2. NOTE: Refer to Fastener Notice .
  2. Install the brake hose assembly to the caliper.

    Tighten:  Tighten the brake hose fitting bolt to 49 N.m (36 lb ft).

    3. Fig 2: View of Brake Hose Retainer Bolt
    GM1969921Courtesy of GENERAL MOTORS CORP.
  3. Install the brake hose retainer bolt (1).

    Tighten:  Tighten the brake hose retainer bolt to 10 N.m (89 lb in).

  4. Connect the wheel speed sensor wire harness clip (2) to the brake hose retainer.
    5. Fig 3: View Of Front Brake Hose Retainer Clip
    GM1969919Courtesy of GENERAL MOTORS CORP.
  5. Install the front brake hose retainer clip (1).
    6. Fig 4: Identifying Front Brake Pipe Fitting
    GM1969918Courtesy of GENERAL MOTORS CORP.
  6. Connect the front brake pipe fitting (1).

    Tighten:  Tighten the fitting to 18 N.m (13 lb ft).

  7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals