LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1122 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Brake Pedal Assembly
    GM1919858Courtesy of GENERAL MOTORS CORP.
  1. Install the brake pedal assembly (1) to the vehicle.
    2. Fig 2: Removing/Installing Steering Column Support Bracket
    GM1919839Courtesy of GENERAL MOTORS CORP.
  2. Install the steering column support bracket (1).
    3. Fig 3: View of Vacuum Brake Booster Bracket
    GM1970023Courtesy of GENERAL MOTORS CORP.
  3. Install the vacuum brake booster bracket (1).
    4. NOTE: Refer to Fastener Notice .
    Fig 4: View Of Upper Steering Column Support Bracket Nuts
    GM1970022Courtesy of GENERAL MOTORS CORP.
  4. Install the upper steering column support bracket nuts (1).

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    5. Fig 5: View Of Brake Pedal Bracket Nuts
    GM1970021Courtesy of GENERAL MOTORS CORP.
  5. Install the brake pedal bracket nuts (1).

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    6. Fig 6: Identifying Vacuum Brake Booster Bracket Nuts
    GM1919816Courtesy of GENERAL MOTORS CORP.
  6. Install the vacuum brake booster bracket nuts (1).

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    7. Fig 7: View Of Vacuum Brake Booster Pushrod Bushing
    GM1919812Courtesy of GENERAL MOTORS CORP.
  7. Install the vacuum brake booster pushrod bushing (1).
    8. Fig 8: View Of Vacuum Brake Booster Pushrod
    GM1919807Courtesy of GENERAL MOTORS CORP.
  8. Connect the vacuum brake booster pushrod (1) to the brake pedal pivot.
    9. Fig 9: Identifying Vacuum Brake Booster Pushrod Retaining Clip
    GM1919805Courtesy of GENERAL MOTORS CORP.
  9. Install the vacuum brake booster pushrod nut (1).

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

    10. Fig 10: Identifying Brake Pedal Position Sensor
    GM1919797Courtesy of GENERAL MOTORS CORP.
  10. Connect the brake pedal position sensor (1) electrical connector.
  11. Install the steering column. Refer to Steering Column Replacement .
  12. Install the park brake pedal assembly. Refer to Parking Brake Lever Pedal Assembly Replacement .
  13. Install the vacuum brake booster. Refer to Power Vacuum Brake Booster Replacement .
  14. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
scientia non olet · About LEMON Manuals