Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new stud from the back side of the hub.
- Install flat washers on the wheel stud.
- With the flat side of a wheel nut against the washers, tighten the wheel nut until the wheel stud head seats against the wheel hub flange.
- Install the wheel bearing/hub assembly. Refer to Rear Wheel Bearing and Hub Replacement .
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
IMPORTANT:
Ensure that the wheel stud is fully seated against the wheel hub flange.