LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1119 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft Link
    GM1371366Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft link to the lower control arm.
    2. Fig 2: Locating Stabilizer Shaft Link Retaining Nuts
    GM1371368Courtesy of GENERAL MOTORS CORP.
  2. Install the stabilizer shaft link to the stabilizer shaft.
    3. NOTE: Refer to Fastener Notice .
    IMPORTANT: Hold the shaft link stud with a hex tool to prevent damage to the link seal.
  3. Install the stabilizer shaft link retaining nuts.

    Tighten:  Tighten the nuts to 90 N.m (67 lb ft).

  4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals